I"ve seen this trouble elsewhere, but I haven"t discovered a solution. I must remove the lens from my fluorescent irradiate fixture so i can readjust the bulbs. It shows up the only way to eliminate the lens would certainly be come remove among the end caps ~ above the fixture therefore the lens might slide out. Yet I can"t view any way to remove the finish caps. To remove them, it appears the pressure that would be forced may be an excellent enough to rest them. I"ve never ever seen such a poor style for a an easy device. Ns could write-up photos if that would help.

You are watching: How to remove fluorescent light cover without clips


*


Pic"s always help. Many times girlfriend just have to flex the clear cover over one side, then it comes right off.

The lens extends well right into the end caps. There is no method sliding the lens either method and climate flexing that would allow it to it is in removed.
Sometimes you gain lucky and the totality frame w/lens lifts and can it is in jiggles loose. Otherwise, it is a game if angles and also patience. Try to acquire one side as high as possible while pulling under on the other. Carry out this after the light has actually been on for a while therefore the plastic lens is a small warmer and not together brittle. I"ve had actually success, I"ve additionally had to change a pair that were much less than cooperative.
My guess is that one or both end caps breaks on and also can be removed by tapping it close to the ceiling to pop it turn off the fixture. The lens would certainly then on slide out, providing you access to the tubes.
I"ll try tapping one finish cap off. So far I"ve only been trying to pry that off. Together I mentioned, sliding the lens totally into either finish cap go not allow the opposite end of the lens come come almost everywhere near dropping down.Added: goldstar wins! The plastic end caps are held to the fixture through two protruding tabs on every side the the finish cap. Unfortunately, tapping lightly on one end damaged these plastic tabs off. Ns don"t care!I now see the correct means is come press really firmly in top top the end of the metal fixture come deform the area so these tabs would then clear the metal fixture"s holes. V the finish cap off, the lens slides out.

See more: Lions And Tigers And Bears Lyrics Wizard Of Oz, Song Parodies


Too bad you had to rest the tabs off one end cap to discover the trick, but, glad you gained it resolved and thank you because that the feedback.
I set up a pair of brand-new 6000K daylight tubes and the area looks an excellent now. So lot so, I desire to adjust the various other two still functioning tubes in a adjacent fixture. Fortunately, that lens has actually a ridge on every side that simply lifts up off the fixture. I"m an experienced now!
I love those. Ns forget what remained in our wash room when we purchase this house, but I instantly replaced whatever it was v two two-tube T-8 fixtures, one 4" and one 2", join end-to-end, and installed 6500K lamps (I think lock are) in them. That"s 120W the daylight appropriate down the center of the room. If friend don"t see a clues on the clean clothing in that room, you sure won"t check out one somewhere else!Hey! go for it, expert!
*
*

starrkingschool.net®, founded in 1995, is the top independent home improvement and fix website. We welcome her comments and also suggestions. All information is provided "AS IS." Website operating problems call webmaster